– Recessed Viton O-ring seals threaded interface from water, snow, ice and dirt
– Machined from 6061 aluminum, blasted, engraved and anodized
– Engraving of our logo is done before anodizing for a very subtle look
– Antennas and stainless steel threaded studs are assembled before packaging using permanent threadlocker
Ford Raptor (2017 - 2020)
Engineering & Manufacturing
*** This product is not intended to be a higher-performing replacement for the factory antenna. It is recommended for use if you have a strong signal with the stock antenna or simply don’t use your AM/FM radio. Returns accepted without question if the antenna doesn’t meet your expectations. **
Not much else to say other than that it does everything I was hoping. Love the way it fits the OEM antenna base perfectly.
Product far exceeds expectation with looks and function. Sizing, finish, and logo look great, beJer that anything I have seen online or in person on other rigs. Reception has yet to be tested out of town but in town reception is as good or better than stock and I was expecting lower performance. Only an antenna, but a great product.
I received the antenna and rear seat release kit yesterday in the mail. I took a break from working from home and installed both of them in about 15 minutes. The antenna looks great and I love the way that it covers the base by going over the edge instead of just butting right up to the base. This will not allow moisture, snow, ice, etc into the base and cause issues. We will see on the trip how the recepLon does in the hills going to Northern Michigan.
An easy install and works just as I was hoping picking up all the local radio stations and some that are not so local. Well manufactured!